IN LINE PLANER BOARDS AND ADD ON OPTIONS

Release Options Can Be Found At PLANER BOARD RELEASES

Back Side View

OR31 Side Planer SST (Available in Left's (OR31L) and Right's (OR31R).  Shown Left            

Each OR-31 Side Planer SST includes:  Orange Side Planer SST, one OR19 release, 6/32 screw, nylon nut, pigtail/screw eye assembly, split ring along with instructions. This item does NOT come with a flag.  Each board is carefully ballasted to run flawlessly in rough water or higher speeds off of your rod line.  They are ideal for Striper, Salmon, and Trout.

An OR18 release can be used in place of the OR19 release.

 

OR12 Side Planer (Available in Left's (OR12L) and Right's (OR12R).  Shown Right                                   

Each Yellow OR12 Side Planer includes a stationary flag, two OR14 releases, two 6/32 screws, two nylon nuts, one split ring,  instructions and is carefully ballasted to run flawlessly in rough water off of your rod line.  This item does NOT come with the Tattle Flag Upgrade on it.  You would have to purchase the OR12TF to convert the board a Tattle Flag board.  Ideal for Walleye and most fresh water fish.

An OR16 clip or an OR18 release can be used in place of the OR14 release. 

 

                     

 

Back Side View

  

OR12P2 Pigtail (For use on OR12L, OR12R, OR31L & OR31R Shown Left

Each pack comes with two pigtails and two split rings.  These are used to have your OR12L, OR12R, OR31L or OR31R for the slide down method.

 

OR12TF  Tattle Flag Upgrade Kit (For use on OR12 & OR31 (SST) Side Planer's) Shown Right

Each kit includes flag, two OR16 clips, wire, spring, washer, screw eye, split ring, 6/32 screw and instructions.  One kit will upgrade one OR12 Side Planer.  This item is ideal for light biting fish.  The flag will pull down when you have a fish on or if you are fouled in weeds.

Replacement Parts Also Available:            

  • ORS2       Spring
  • WIRE       Wire
  • NW           Nylon Washer
  • SCREYE    Screw Eye
  • SPLTRNG  Split Ring
  • TFINSTR  Instruction Sheet

 

            

OR32 Night Light 2 (For use on OR12's and OR31's) Shown Right

OR32 comes with two red night lights, four 1.5 volt batteries and instructions.  You can mount these lights to your OR12L, OR12R, OR31L or OR31R Side Planer boards for night or low light fishing.  This is a stationary light.  Light is visible for 360 degrees!  So now all boaters can see where your boards are running!

THIS ITEM IS NOT TO BE USED WITH THE OR12TF (Tattle Flag Set Up).      

 

   

OR33 Night Light 3 (For use on OR12's and OR31's) Shown Left

OR33 comes with two green night lights, four 1.5 volt batteries and instructions.  You can mount these lights to your OR12L, OR12R, OR31L or OR31R Side Planer boards for night or low light fishing.  This is a stationary light.  Light is visible for 360 degrees!  So now all boaters can see where your boards are running!

THIS ITEM IS NOT TO BE USED WITH THE OR12TF (Tattle Flag Set Up).  

 

OR29 Speed Bead (For use on OR12's and OR31's)   Shown Right

The OR29 is a quick on and off stop that is placed directly on your fishing line.  It will stop the board from sliding down the rod line and into the fish.

The stocking color of this item will vary.

               

HOME       ORDER FORM